FLOOR PAN & TRUNK RESTORATION INSTRUCTION SHEET
Step 1 : Remove all loose
material with wire brush and vacuum thoroughly..
Step 2 : Wash area with POR-15 Marine Clean mixed
with hot water , then rinse thoroughly
.. Depending on the condition of the floor pan or truck area mix Marine Clean
with hot water from a 1 to 3 ratio , to a 1 - 10 ratio ..
Step 3 : Spray area to be restored with POR-15
Metal Ready and keep wet for 20-30 minutes ; heavy rust removal will take longer
.. Rinse thoroughly with water and dry .. It is very important that the metal is
completely dry before applying POR-15 Rust Preventive Paint .. Use a hair dryer
to speed up dry time, then wait overnight to make sure no moisture remains in
the pores of the metal ..
Step 4 : With a scissors , cut pieces of POR-15
Power Mesh Fabric to sizes desired .. Please Note ! If holes in the floor pan
exceed 1" in diameter , cover them from the underside with duct tape to avoid
temporary sag .. Duct tape can easily be removed afterward ..
Step 5 : Apply a thin but covering coat of POR-15
Silver to the floor pan and place the pre-cut corresponding piece of POR-15
Power Mesh Fabric directly into the wet surface .. Now apply more paint until
the fabric is fully impregnated , but not puddled ; too much paint at this
time will result in bubbling , which is undesirable and counter-productive ..
Let dry 4-5 hours or overnight ..
Step 6 : Use POR-15 Epoxy Putty as needed to fill
in the low areas, welds, etc. Drying time for putty will vary according to
ambient temperature .. (surrounding area ) .. Best time to apply putty is when
POR-15 coating is dry to the touch but with a slight finger-drag remaining ..
Step 7 : Topcoat with one coat of POR-15 Chassis
Coat Black .. Remove duct tape from underside of floor pan and apply two coats
of POR-15 Rust Preventive Paint ..
Information contained herein is to our knowledge true and
accurate, but all
recommendations or suggestions are made without guarantee.
Since the conditions of its use are beyond our control, RestoMotive
Laboratories/POR-15, Inc. disclaims any liability incurred in connection
with the use of its products and information contained herein.
No person is authorized or empowered to make any statement or
recommendation not contained herein, and any such statement or
recommendation so made shall not bind the Corporation.
Furthermore,
nothing contained herein shall be construed as a recommendation to use
any product in conflict with existing patents covering any material or its use,
and no license implied or in fact is granted herein under the claims of any
patents.
POR-15 INC.