POR-15 Metal Mask Application Guide
Metal Mask is a single component polyurethane
coating that makes any metal surface look exactly
like new bare metal. Metal Mask is non-porous and will not crack, chip, or peel when properly applied. It
has great scratch and abrasion resistance and is not
sensitive to UV light. Follow directions carefully and
you will be rewarded with the finest protective coating
for metal available anywhere!
Directions for Use:
For best results, when applying over bare metal, first
prep your job with POR-15 Metal-Ready. Keep wet
for 15 minutes, then wash off thoroughly with water
and dry. Stir contents of can well, then apply MetalMask with a foam brush. Try to avoid painting back
and forth. Apply in thin, covering coats, using single,
steady strokes to avoid flooding your job with too
much paint, which could cause it to run and streak.
Continue to stir Metal Mask so that metallic pigments
remain in solution as you paint. Allow 3 or 4 days for
Metal Mask to reach maximum hardness.
Spray Application:
Use 25 - 30 lbs(170-210Kpa). pressure for normal
gloss. Use only POR-15 Solvent for thinning.
Precautions: Avoid skin contact. Remove from skin
at once to avoid temporary staining. Use of protective
gloves and ventilating equipment is recommended.
NOTE: Organic vapor particulate respirators, NIOSH/MSHA approved, must be used when spraying Metal
Mask in a well-ventilated area. When spraying in an
enclosed area, air-supplied respirator must be used.
Moisture will shorten the life of unused Metal Mask.
Seal can immediately after using. Keep out of reach
of children. Harmful or fatal if swallowed. Use in
well-ventilated areas only.
Hazardous ingredients: Oil modified polyurethane, Cas:
Proprietary, Aliphatic hydrocarbon, Cas#64741-41-9, Aluminum,
Cas#7429-90-5, Manganese Oxide, Cas#1313-13-9, Iron Oxide,
Cas#1309-37-1, Silicon Dioxide, Cas#7631-86-9, Aluminum
Dioxide, Cas#1344-28-1
POR 15 inc